🔱
[BOOT] one board, every radio OK
T-EMBED CC1101 PLUS · 5 RADIOS ONBOARD
05 // THE BOARD

Verified hardware

Every value here comes from the firmware's own pin map for this board, cross-checked against LilyGO's sources. Nothing is aspirational.

Core ESP32-S3

MCUESP32-S3 + PSRAM
DisplayST7789 170×320, landscape
Inputencoder + SELECT + BACK
StoragemicroSD, shared SPI
Power gateGPIO15 held HIGH

Radios ONBOARD

Sub-GHzCC1101, ~300-928 MHz
Band selectSW0 / SW1 switched
2.4 GHznRF24L01+ (Plus SKU)
NFCPN532, I2C 0x24
IRTX + RX

Extras EVERYTHING ELSE

LED ringWS2812B ×8
AudioNS4168 I2S speaker
MicPDM
BatteryBQ25896 + BQ27220
SPI clock40 MHz (vendor value)
▲ TWO REAL CAVEATS, STATED UP FRONT

The nRF24 chip-select pins are triple-booked with UART0 and the external header, so serial logging and 2.4 GHz traffic can interfere, and LilyGO's own issue tracker notes some Plus units losing nRF range over time. And because the SD card, the CC1101 and the nRF24 all share one SPI bus with the display, every driver has to cooperate on that bus rather than assume it owns it — a lesson this port learned the hard way. The sharpest example: the CC1101’s SO pin is also its GDO1, so unless it is left three-stated it drives that shared MISO line even while its own chip-select is idle — quietly corrupting every nRF24 read, pulling one-bits down while zero-bits stayed clean. It presented as flaky hardware for weeks. It was one register.

T-Embed CC1101 Plus vs Cardputer-Adv

One codebase, selected at build time. What changes is the shell around it.

T-Embed CC1101 PlusCardputer-Adv
Display1.9 inch, 320×1701.14 inch, 240×135
InputRotary encoder + 2 buttonsFull QWERTY
Sub-GHzOnboard CC1101Hydra hat
2.4 GHz nRF24Onboard (Plus SKU)Hydra hat
NFCOnboard PN532None
IRTX + RX onboardTX onboard
LoRa + GNSSNot onboardLoRa hat
Wired EthernetNot onboardW5500 hat
ExtrasRGB ring, fuel gaugeSpeaker, mic

Neither wins outright. The Cardputer keeps a real keyboard and reaches LoRa, GNSS and wired Ethernet through hats. The T-Embed folds sub-GHz, 2.4 GHz, NFC and IR onto one board and adds a fuel gauge. Pick the body the mission wants.